组织匀浆仪,通量:24x1.5ml;时间:0-15min;强度:12档 Bullet Blender Storm
The Bullet Blender® enables you to homogenize, disrupt, or lyse up to 24 tissue or cell culture samples at a time. Load the samples into standard polypropylene tubes, then place them in the Bullet Blender. The "bullets" in the instrument vigorously strike all of the tubes and homogenize your sample in minutes. The Bullet Blender homogenizer Gold models keep samples at 4°C!
Why choose the Bullet Blender?
Consistent and High Yield Results!
The Bullet Blender homogenizer prepares up to 24 samples in just minutes. All of the samples are automatically homogenized in the same manner, with high yields, so there is very little variation from sample to sample. See the Protocols tab for preparation times and speeds.
Samples Stay COOL
No cool down periods required. There is very little heating of the samples because the sample tubes vibrate vigorously in air, keeping them cool as the Bullet Blender applies rapid bursts of agitation. Many of our competitors’ bead mill homogenizers require cool down periods because the samples heat up due to a lack of cool air flowing past the tubes, and/or continuous high frequency agitation. The Bullet Blender’s unique, elegant design also means that the motor does not need to agitate any heavy platforms or plates. Thus the Bullet Blender uses very little power, further keeping the samples cooler, and it will last for many years. Early units from 2006 are still in use.
Learn more about cooling in the Bullet Blender!
So Many Uses, So Easy To Use
In addition to homogenizing tissue, plant matter, small organisms and microorganisms, the Bullet Blender can also isolate live bacteria from organs, generate nanoparticles, and isolate organelles from cells.
It’s so easy to use. Simply place your sample, beads and buffer in standard tubes, and load the tubes into the Bullet Blender homogenizer. Tune the extent of disruption by adjusting the run time and speed. Afterwards, place the sample tubes in a centrifuge to separate the lysate. No special holders are needed. There are no clamp plates nor locking rings to fiddle with.
Learn more about how easy the Bullet Blender is to use!
No Cross-Contamination or Sample Loss
There are no probes or blades to cause cross contamination or sample loss, which also means there are no parts to clean between runs. The sample tubes are kept closed and self-contained during homogenization.